Daisy Chain Cable Kit
9.99

This kit enables you to build daisy chain cables for chaining multiple 4x4 Drivers together. 

Each kit contains the following components

  • Six feet of 8 conductor ribbon cable, 0.05" pitch
  • Six 8 pin 0.1" polarized rectangular IDC connectors, FCI p/n 71600-008LF or equivalent

Assembly instructions

Add To Cart
I2C Cable Kit
9.99

 

This kit enables you to build cables for chaining multiple I2C devices from either Logos or Snootlab together. The cables carries SDA, SCL, 5V, 3.3V, and GND signals.

Each kit contains the following components

  • Six feet of 10 conductor ribbon cable, 0.05" pitch
  • Six 10 pin 0.1" polarized rectangular IDC connectors
  • One 10 pin right angle female mating connector
Quantity:
Add To Cart
IP68 Enclosure
9.99

Our bridge amplifier module has been designed so that it can be trimmed to fit within a Bulgin Buccaneer Ethernet cable joiner. Provided you use appropriate cable, this provides your amplifier with IP68 environmental protection as well as robust impact protection. The IP68 rating specifies that this enclosure is dust-tight and watertight against continuous immersion to a depth of at least one meter. 

Quantity:
Add To Cart
4x4 Driver Connector
1.99

 

This kit contains one DB25 solder cup connector that mates to the power connector on our sixteen channel driver shield.

Quantity:
Add To Cart
Bridge Amplifier Mating Connector Kit
2.99

 

This kit contains two (2) four pin connector housings that mate to the input and output connectors on our bridge amplifier board, and ten (10) matching crimp sockets. 

Add To Cart
Bridge Amplifier Screw Clamp Connector Kit
4.99

 

This kit contains two (2) four terminal 3.5mm screw clamp terminal blocks from Phoenix Contact. These solder to the ends of our bridge amplifier boards, allowing you to directly connect wires to the amplifier from your sensor and data acquisition system.

Quantity:
Add To Cart
Zigduino r2 External Antenna Kit
15.00

This is a through-hole MMCX connector plus an external antenna on a cable. This allows you to swap the stock antenna for one with better performance. Note that removal of the built-in antenna is required.

Quantity:
Add To Cart